Page 1 of 1

I did not find the settings

Posted: Sat Aug 27, 2016 1:52 pm
by seydel
I did not find the settings шт Xrecode III, these settings are in Xrecode II

https://www.dropbox.com/s/ap8pys3zus3d5 ... I.png?dl=0

I need to create a folder in the original folder with the specified tag.

Re: I did not find the settings

Posted: Sat Aug 27, 2016 2:46 pm
by admin
Just use the same pattern in the Pattern Settings for Filename.

Re: I did not find the settings

Posted: Sat Aug 27, 2016 4:26 pm
by seydel
admin wrote:Just use the same pattern in the Pattern Settings for Filename.
It is impossible, I can not figure out where you need to make changes.

Re: I did not find the settings

Posted: Sat Aug 27, 2016 5:15 pm
by admin

Re: I did not find the settings

Posted: Sat Aug 27, 2016 5:52 pm
by seydel

Re: I did not find the settings

Posted: Sat Aug 27, 2016 6:29 pm
by admin
Looks fine to me. What exactly is the problem? If you are converting files from one format to other, then this pattern will work. Are you using a CUE as input? Then you need to change the pattern for the CUE.